Search found 7 matches
- Thu Feb 21, 2013 8:33 am
- Forum: Centralized Controller Platforms
- Topic: Lag time when switching modes
- Replies: 2
- Views: 5578
Re: Lag time when switching modes
I keep sending NONE commands and evaluate the response, until the mode swicth was successfull. I do this for all configuraiton changes. However, care mus tobviously be taken, that commands are not sent too ofaten. The spec says that the maximum rate at wich commands can be sent to the paltform is 10...
- Thu Feb 21, 2013 8:30 am
- Forum: Centralized Controller Platforms
- Topic: UDP communication ports RMPX440LE
- Replies: 6
- Views: 11143
Re: UDP communication ports RMPX440LE
Thanks, I will try that.
Best,
Georg
Best,
Georg
- Thu Feb 14, 2013 5:48 pm
- Forum: Centralized Controller Platforms
- Topic: UDP communication ports RMPX440LE
- Replies: 6
- Views: 11143
Re: UDP communication ports RMPX440LE
Hi again, after having my code running in principle, I tried to change the port using the python demo program. Unfortunately it does not allow me to enter non privileged ports. I did not try the ful range of port numbers, but I definiely canot sent port numbers bigger that 1024. I now use setiud fla...
- Sat Feb 02, 2013 7:50 pm
- Forum: Centralized Controller Platforms
- Topic: RMP 440 Omni---no power
- Replies: 12
- Views: 18338
Re: RMP 440 Omni---no power
Hi, the python code is not "fully" portable. When I tried it on Linux, it had some problems finding some icon, I do no recall which however. After I commented out all lines referring to the icon (a lot actually), the code sort of runs. I have the impression, that the cycle of the main communication ...
- Sun Dec 02, 2012 8:44 am
- Forum: Centralized Controller Platforms
- Topic: UDP communication ports RMPX440LE
- Replies: 6
- Views: 11143
UDP communication ports RMPX440LE
Hi, I noticed that I can configure IP address and port number of the onboard controller. How does it work on the PC side? The Python demo code uses a port 55 (?) when creating the socket. On Linux this (below 1024) privileged port, that requires th process to be run by root. This is a bit unconvenie...
- Tue Oct 23, 2012 9:53 am
- Forum: Centralized Controller Platforms
- Topic: Recommended tire pressure for 440LE
- Replies: 1
- Views: 4390
Recommended tire pressure for 440LE
Hi,
since there does not seem to exist a manual fpr the 440s, I do ask this here: What ist the recommended tire pressure for the 440LE?
Best,
Georg
since there does not seem to exist a manual fpr the 440s, I do ask this here: What ist the recommended tire pressure for the 440LE?
Best,
Georg
- Tue Oct 23, 2012 9:52 am
- Forum: Centralized Controller Platforms
- Topic: PythonDemoOCU on Linux
- Replies: 1
- Views: 4413
PythonDemoOCU on Linux
Hi,
not beeing a Python guy yet, how much changes will be needed to make the Dmoe Programs run on Linux (using the ethernet connection!) ?
Best,
Georg
not beeing a Python guy yet, how much changes will be needed to make the Dmoe Programs run on Linux (using the ethernet connection!) ?
Best,
Georg