Thank you for your reply. Then we have two questions:
(1) How to externally close the yaw loop? We do need to turn the robot with a low speed.
(2) What could we do to make the robot turn with a low speed if we add some payload more than 200 pounds?
Thanks!
Yunyi
Search found 3 matches
- Mon Nov 05, 2012 4:43 pm
- Forum: Deuce Board Platforms
- Topic: Question about RMP 400 traction
- Replies: 5
- Views: 15509
- Wed Oct 10, 2012 2:38 pm
- Forum: Deuce Board Platforms
- Topic: Question about RMP 400 traction
- Replies: 5
- Views: 15509
Re: Question about RMP 400 traction
Hi, Craig, Thank you very much for your reply. (1) We tested it on flat concrete surface with tire pressure more than 9 PSI. The problem is the same. And the system didn't not heat up obviously. (2) Our first RMP 400 has a payload of around 185 lbs and needs at least 3 deg/s turning speed to turn. O...
- Wed Oct 10, 2012 11:41 am
- Forum: Deuce Board Platforms
- Topic: Question about RMP 400 traction
- Replies: 5
- Views: 15509
Question about RMP 400 traction
Hello, We are doing experiment with our RMP 400 and found the following problem. We checked the manual but are not sure about the reason. So could you please help us to check the problem? The problem is as following: After we charge the battery, the voltage is around 76 V. At this time, when we send...